SCM Group DMC SD10-CS95 37" Single Head Wide Belt Sander

Machine Standard Features:

• Rubber coated pressing rollers before and after sanding unit
• Additional flexible hold-down plate before sanding unit.
• .7 HP 2 speed feed unit. Feed speeds set at 15 and 30 feet per minute
• Electronic digital thickness readout of work table position
• Electronic positioning of the work table 
• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability 
• Accurate and reliable electronic tracking of abrasive belt 
• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt 
• Front and rear emergency stop buttons
• Automatic emergency stop of machine for
• sanding belt breaking, tensioning, over tracking
• opening of the access door to the operating groups 
• absence of compressed air
• overload on main motors
• Amperage meter for main motors allows maximum utilization of available horsepower
• Main disconnect switch with the ability to be locked out by padlock
•  50 shore, negative profile (waffle style) rubber feed mat
• Infeed and Outfeed tables with 2 rollers each
• Automatic table thickness device

1st Working Unit

Working Unit Type:

Combination Head:

Motor Hp:

18 HP

Motor Type:

Single Speed

Abrasive Belt Speed:

18 mps

Drum Size:

120 mm (4.75”)

Drum Type:

85 Sh Rubber

Platen Size:

50 mm (2”)

Platens Included:

Two

Abrasive Belt Length:

60”